Eastron ESCT-T36 Split Core Current Transformer
- Single phase split core CT
- 100A to 600A range
- Complete with 1M flying lead
- 36mm aperture
- Description
- Additional information
- More Products
- Store Policies
- Enquiries
Description
The Eastron ESCT-T series of split core current transformers are designed for fast and easy installation. The split core deign permits non-contact current measurements through magnetic field induction without requiring that the primary wire be taken off line and disconnected for CT installation. This method permits a safer easy and portable current measurement. An internal precision burden resistor across the secondary winding of the CT provides a safe low voltage output and permits safe opening of the secondary circuit.
- Single Phase Split Core Current Transformer
- 100A to 600A range
- Complete with 1M flying lead
- 36mm aperture
Additional information
| Primary Amp's | 100/1A, 100/5A, 150/1A, 150/5A, 200/1A, 200/5A, 300/1A, 300/5A, 400/1A, 400/5A, 500/1A, 500/5A, 600/1A, 600/5A |
|---|
-
-
-
Circutor RGU-10B Earth Leakage Relay
Delay: 00.2-10s on instantaneous or selective
Dimensions: 3-DIN Module
Auxillary Power supply: 230VAC (20% difference)
Output contacts: 250 Vac, 6A
Remote signal: Pre-alarm -
Circutor WGC Range Earth Leakage Current Transformers
Sizes available –
25mm
35mm
55mm
110mm
140mm
180mm
220mm x 105mm
350mm x 150mm
500mm x 200mm -
APHEX Steel enclosure to fit a surface mounted meter
To save time during installation, SHM XMP1S is a steel enclosure for surface mounted meter. Fully wired to Fuse holders, Neutral and CT shorting terminals.
The XMP1S Allows any surface mounting…
-
B Meters, GSD8-I Screwed WRAS & MID Approved Cold Water Meter
Single jet, dry dial, direct reading on 8 numerical rolls.
Produced in the versions for cold water and hot water
360° rotating dial.
Inductive pre-equipment for the installation of data communication modules M-BUS…
General Enquiries
There are no enquiries yet.
